Five tips for parts that cut cleanly

Design · 7 October 2026

Small changes in the drawing that make parts cut better, fit better and cost less.

A laser cutting head over a sheet of dark wood veneer, a bright point where it cuts
A laser cut in veneer, a fraction of a millimetre wide.

1. Holes at least as wide as the sheet is thick

Smaller holes can be cut, but their edges suffer. In 3 mm steel, draw holes of 3 mm and up.

2. Keep holes away from the edge

Leave at least the thickness of the sheet between a hole and an edge, or the strip between them distorts.

3. Round the inside corners

A router bit is round, so inside corners come out with its radius. Draw them rounded, or add a small relief, and parts fit as drawn.

4. Allow for the width of the cut

A laser takes away 0.1 to 0.3 mm, a router the width of its bit. The machine allows for it, so the part keeps its size, but slots and tabs that must fit need a little room.

5. Give fits some play

A tab fits a slot best when it is 0.1 to 0.2 mm smaller. For a press fit, cut a test piece first.

Want us to look at your drawing?

Send it over. We point out anything that will not cut cleanly before we price it.

Get in touch