Send a drawing we can cut
Guides · 4 November 2026
Most delays start in the file, not on the machine. These are the six things a workshop checks before anything is cut.

1. A file the machine can read
DXF or DWG for flat parts, STEP for 3D models, SVG or PDF if that is all you have. A photo or a scan is a starting point, not a cutting file.
2. Full size, in millimetres
Draw at 1:1 and say the units. A part drawn in inches and read as millimetres comes out 25.4 times too small.
3. Closed outlines
Every outline must meet itself. A gap of a hundredth of a millimetre is enough for the software to see an open line it cannot cut round.
4. One line per cut
Lines drawn twice, one on top of the other, are cut twice: slower, and with a wider, darker edge. Delete the duplicates.
5. Text as outlines
Fonts are not sent with the file. Turn lettering into outlines, and mind the insides of letters like O and A: they fall out unless they are bridged.
6. Material, thickness and quantity
Write them on the order, not only in the file name. If the part has a grain direction or a good face, mark it on the drawing.